looking at having a cage built by krawltex. what do you guys think?

ive been wanting a new cage built for quite some time now and after seeing alot of wranglers rolled over on jeepforum it makes me want one even more. mainly for safety on road. ive always liked the sport cages that came on the YJs (the ones similar to what the CJs had) but with a few extras like having an A piller put in up front, a cross bar across the dash and along the top of the windshield frame. i would have a V in the front window (dont know the tech name for it) i was also thinking of running a bar along the driver and passenger seats from the floor to the B pillar. along the top above the driver and passenger from the B pillar to the A, id have two bars run along each other about i dont know ~12" wide so i could build an over head console to put my CB in. then in the back off of the B pillar id have the bars angle down like the CJs/YJs and have a bar run from drivers side to the passengers side along the back to support that. also i would have all this tied into each other along the floor. i could draw it up and take a pic so its better understood. i dont have MS Paint on this computer other wise i would use that. ideas and thoughts? how much do you think this would end up costing?

found you can do it in photoshop:



should i have the cross section on the B pillar? what about that for above the driver/passenger?

Ptr wrote:looks like shit

yeah i dont have the skill to build it thats for sure. just wondering if im missing something that would make it stronger or if i should change something around

id rather it be safe than cheap